Installation Guide
Step 6:
Fig. 8
Fig. 7
Step 8:
Fig. 9
Step 9: (Optional - requires accessory part # 171-7626, Sold Separately)
Cover exposed wire with Deck Impressions wire covers. Fig. 10.
Mixing Lighted and Non-Lighted Balusters?
Fig. 10
Align pierce connectors with 16 AWG SPT-2W landscape wire. Press firmly to pierce wire. Fig. 7. For installation of non-lighted
balusters, follow instructions included with accessory hardware pack 171-7620 (sold separately).
Limited 5 Year Warranty: Creative Industries warrants the lighted balusters to be free from defects in material and workmanship for a period of five
(5) years from the date of purchase. This warranty applies only to the original consumer purchaser and only to products used in normal use and
service. If this product is found to be defective, Creative Industries' only obligation and your exclusive remedy, is the repair or replacement of the
product at Creative's discretion, provided that the product has not been damaged through misuse, abuse, accident, modifications, alterations, neglect
or mishandling. This warranty shall not apply to any product that is found to have been improperly installed, set-up, or used in a way not in
accordance with the instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of an accident, misuse,
abuse, negligence, alteration, or faulty installation, or any other failure not relating to faulty material or workmanship. This warranty shall not apply to
the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. Creative does not warrant and
specially disclaims any warranty, whether express or implied, of fitness for a particular purpose, other than the warranty contained herein. Creative
Industries specifically disclaims any liability and shall not be liable for any consequential or incidental loss or damage, including but not limited to any
labor expense costs involved in the replacement or repair of said product. Some states do not allow the exclusion or limitation of incidental
consequential damages, so the limitations and exclusions above may not apply to you. This warranty is in lieu of all other express or implied
warranties. All implied warranties, including the warranty of merchantability and the warranty of fitness for a particular purpose are hereby modified to
exist only as contained in this limited warranty and shall be of the same duration as the warranty period stated above. Somme states do not allow
limitations on the duration of an implied warranty, so the above limitation may not apply to you.
Step 7: Secure pierce connector end of baluster to rail connector by
sliding connector sleeve up to mate with threaded end of rail connector.
Fig. 8.
Insert opposite end of baluster into slotted opening
of rail connector and slide connector. Slide
connector sleeve to cover rail connector. Note: The
connector sleeve has a thicker side that should mate
with the slotted opening of the rail connector. Turn
the sleeve until the thicker side of the sleeve aligns
with the opening of the rail connector. Push onto rail
connector and twist to lock. Fig. 9.
Step 10: Complete the installation by connecting one end of the 16
AWG SPT-2W landscape wire (available at retailers carrying Deck
Impressions lighted balusters) to a 12 volt landscape transformer
following the instructions supplied with the transformer.
Standard 1/2" diameter aluminum balusters can be mixed with Deck
Impressions lighted balusters. For installation of standard 1/2" diameter
aluminum balusters, you will need Deck Impressions accessory part #
171-7620 (Sold Separately).
Tip: When using pressure-treated lumber, avoid the use of wet lumber.
Wet lumber may twist or warp, causing damage to the assembled
system.
THE MAIN LOW VOLTAGE CABLE IS INTENDED FOR SHALLOW BURIAL - LESS THAN 6 INCHES (152 MM)
THIS DEVICE IS ACCEPTED AS A COMPONENT OF A LANDSCAPE LIGHTING SYSTEM WHERE THE SUITABILITY OF
THE COMBINATION SHALL BE DETERMINED BY CSA OR LOCAL INSPECTION AUTHORITIES HAVING JURISDICTION.
WARNING - RISK OF ELECTRIC SHOCK. INSTALL ALL LUMINARES 10 FEET
(3.05m) OR MORE FROM A POOL, SPA, OR FOUNTAIN.