Installation Guide

877.492.4334 || Deck-Top.com || Sales@Deck-Top.com || 13575 58th Street North, Suite

323 Clearwater, FL 33760

OFFICIAL INSTALLATION GUIDE

IMPORTANT

SUGGESTED ADHESIVES

PRIOR TO PURCHASING DECK-TOP:

First determine how many planks of Deck-Top are needed on your dock or deck and measure their lengths. Deck-Top is

currently produced in 4 ft, 8ft and 12 ft. standard lengths. Other lengths and colors are available by special order. Feel

free to contact us if you any questions.

Determine how many edges will be exposed and require optional 1 1/2” x 1 3/4” PVC edge trim covering. Trim pieces

are available in 12 ft. lengths. Note: 1 1/2” x 1 3/4” PVC trim can be installed using the same adhesive used on Deck-Top

planks.

In order to allow proper fit and drainage, it is recommended to have a minimum 3/16” space between deck boards

before starting to install Deck-Top.

DECK-TOP INSTALLATION PREPARATION:

Make sure that the existing structure is free from grease and/or loose debris prior to Deck-Top application. Deck-Top will

conform to the shape of your existing decking, so distressed and/or warped boards should be removed and replaced prior

to installation.

If dock/deck boards (composite or wood) are not securely nailed down to ﬂoor joists, it is strongly recommended to

screw each board down at all points of contact with the ﬂoor joists (stainless steel screws are recommended). This will

help ensure that there are no loose boards after Deck-Top is installed. If possible, we also advise the removal and

reattachment of all existing fasteners and cleats after the adhesive has cured.

If the existing gap between your deck boards is 1/4” or more, but it has been filled in by paint or other debris, additional

steps should be taken. Apply a 1/4” router bit or circular saw run between the board, at least 1/2” deep to provide enough

room for Deck-Top to fit over the original planks. If your existing deck boards were installed too close together and are less

than 3/16” apart, it is recommended that you remove the planks and re-space them accordingly. This process will ensure

that your existing decking is securely attached prior to installing Deck-Top.

PAGE 1
OFFICIAL INSTALLATION GUIDE IMPORTANT | SUGGESTED ADHESIVES PRIOR TO PURCHASING DECK-TOP: First determine how many planks of Deck-Top are needed on your dock or deck and measure their lengths. Deck-Top is currently produced in 4 ft, 8ft and 12 ft. standard lengths. Other lengths and colors are available by special order. Feel free to contact us if you any questions. Determine how many edges will be exposed and require optional 1 1/2” x 1 3/4” PVC edge trim covering. Trim pieces are available in 12 ft.
PAGE 2
DECK-TOP ADHESIVE INSTALLATION: Select a Deck-Top approved adhesive. You must use a Polyurethane PVC to Wood All-Weather based adhesive with Deck-Top. These types of adhesives have been vigorously tested and tried over time against the elements. Please see page 1 for a complete list of recommended adhesives. Apply a bead of adhesive on each inside vertical lip on the right and left sides of Deck-Top.