Installation Guide

877.492.4334 || Deck-Top.com || [e-mail] || 13575 58th Street North, Suite
323 Clearwater, FL 33760
© 2019 T&C Decking Products, Inc. || All Rights Reserved || Patent Pending: #16248027
2
DECK-TOP ADHESIVE INSTALLATION:
Select a Deck-Top approved adhesive. You must use a Polyurethane PVC to Wood All-Weather based adhesive with
Deck-Top. These types of adhesives have been vigorously tested and tried over time against the elements. Please
see page 1 for a complete list of recommended adhesives.
Apply a bead of adhesive on each inside vertical lip on the right and left sides of Deck-Top.
On the underside of the Deck-Top plank, run a back-and-forth bead of adhesive (in a z-like motion) from end-to-
end over the full length of the plank. This will ensure proper coverage when Deck-Top is placed on top of your
decking. One 9 oz. tube of approved adhesive should be used for every 12 linear feet of Deck-Top.
If any excess glue is applied to any other surface, clean area immediately. Any uncured sealant needs to be
removed by using the manufactures’ recommended cleaners. Bostik Specialty Sealant Remover™ or
Mineral Spirits are the recommended cleaning agents. Cured sealant is usually very difficult to remove
without altering or damaging the surface to which the sealant has been misapplied.
Place the adhesive-covered Deck-Top plank on top of a decking board with the adhesive-covered side
touching the decking board.
Once Deck-Top is placed on top of the decking board, immediately apply pressure to the top surface from end to
end.
Follow the adhesive manufacturer’s instructions and recommendation on drying time before walking on your
new deck surface.
CLEANING
QUESTIONS? CONCERNS? JUST NEED SOME HELP?
CONTACT CUSTOMER SUPPORT: