Installation of t-tracks: Easy or Not
TOOLS REQUIRED
• Drill
• 1/16” drill bit
• 5/32” drill bit
• #3 Phillips screwdriver (Caution: You’ll most likely strip out the screws if you use a #2 screwdriver. Yes, we’ve done that...)
STEP 1Place the track in the slot on the deck as shown below (left). The tracks can be oriented to either the tailgate end or the cabside end
of the deck, but make sure each track hole is over a deck dimple (those dimples correspond to the steel tubes, see below, right)
EASY MISTAKE # 1: The track can be placed on the tailgate end or the cabside end of the deck. If you orient the tracks incorrectly,
all the track holes will not match all the steel tubes (marked by dimples) you are drilling into. Make sure the pre-drilled holes (on
the track) are ALL over the dimples. And whatever you do, DO NOT DRILL ANY HOLES YET!
THE STEEL TUBES
WE’RE AIMING FOR
(underside of the deck)
EASY MISTAKE # 2: Drill
through both sides of steel
tubes. ONLY drill through
the top of steel tube
EASY TO DO RIGHT:
Read AND FOLLOW the instructions
provided below
REALLY EASY TO DO WRONG:
There are five SUPER EASY ways to screw up.
RESULT: You WRECK your deck

Summary of content (2 pages)