Installation Guide

Installation of t-tracks: Easy or Not

TOOLS REQUIRED

• Drill

• 1/16” drill bit

• 5/32” drill bit

• #3 Phillips screwdriver (Caution: You’ll most likely strip out the screws if you use a #2 screwdriver. Yes, we’ve done that...)

STEP 1 • Place the track in the slot on the deck as shown below (left). The tracks can be oriented to either the tailgate end or the cabside end

of the deck, but make sure each track hole is over a deck dimple (those dimples correspond to the steel tubes, see below, right)

EASY MISTAKE # 1: The track can be placed on the tailgate end or the cabside end of the deck. If you orient the tracks incorrectly,

all the track holes will not match all the steel tubes (marked by dimples) you are drilling into. Make sure the pre-drilled holes (on

the track) are ALL over the dimples. And whatever you do, DO NOT DRILL ANY HOLES YET!

THE STEEL TUBES

WE’RE AIMING FOR

(underside of the deck)

EASY MISTAKE # 2: Drill

through both sides of steel

tubes. ONLY drill through

the top of steel tube

EASY TO DO RIGHT:

Read AND FOLLOW the instructions

provided below

REALLY EASY TO DO WRONG:

There are five SUPER EASY ways to screw up.

RESULT: You WRECK your deck

PAGE 1
Installation of t-tracks: Easy or Not EASY TO DO RIGHT: REALLY EASY TO DO WRONG: TOOLS REQUIRED Read AND FOLLOW the instructions There are five SUPER EASY ways to screw up. • Drill provided below RESULT: You WRECK your deck • 1/16” drill bit • 5/32” drill bit • #3 Phillips screwdriver (Caution: You’ll most likely strip out the screws if you use a #2 screwdriver. Yes, we’ve done that...) STEP 1 • Place the track in the slot on the deck as shown below (left).
PAGE 2
Installation of t-tracks (continued) STEP 2 • Center the track end slots over BOTH the end dimples as best you can.