Installation Guide

Installation of t-tracks (continued)
STEP 2 • Center the track end slots over BOTH the end dimples as best you can.
You’ll need to slightly shift the track to get it as centered as possible
a) Drill a starter hole in each
END DIMPLE ONLY using a 1/16” bit
EASY MISTAKE # 4: DO NOT drill
interior holes yet; only the end holes
b) With the track in place, drill a 5/32”
hole on each end, CENTERED as
best you can over the dimples
c) Screw ends of each track in place
with pan head screws
(not countersunk) and washers
with #3 Phillips screwdriver
EASY MISTAKE # 3: DO NOT START DRILLING YET!
STEP 4 • If you’ve gotten to this
point following the directions,
it should be a cake walk
from here:
a) Drill interior starter holes using a 1/16” bit
b) Drill your 5/32” holes
c) Install remaining countersunk screws
NOTE: Even if you’ve been careful, some
track holes won’t be perfectly centered over
the interior dimples. That’s OK, you’re still
mounting into the steel tubes
EASY MISTAKE # 5: Using a
#2 Phillips screwdriver
STEP 3 • After you’ve checked to make sure you’re lined up properly,
fore & aft: