Installation Guide

STEP 6: INSTALL DRAWER WHEELS
• There is a left and a right corner bracket for each drawer–bolt brackets in place.
(use the 2” bolts for the upper back wall bracket hole); bags 6A and 6B.
• Use tube brace with two bolts to connect the two corner brackets; bag 6C.
• Insert axle through wheel and affix to drawer bracket; bag 6D. Do this for each wheel (4 times).
• Turn drawer upside down and align the holes in the L-braces (loose in system box) with the drawer
holes. NOTE: Start L-brace with hole closest to handle.
• Simply use your thumb to push the weld nuts into each hole. Once weld nuts are in place, turn the
drawer upright and insert the screws (snug but not too tight); bag 6E.
• Repeat for all drawer sides.
6A
6B
6E
6C
6D
IF YOU PURCHASED ACCESSORY
DRAIN HOLE PLUGS, INSTALL NOW.
SEE RED ARROW. (INSTRUCTIONS ARE
INCLUDED WITH DRAIN PLUGS)
WELD NUT
2” BOLT