Installation Guide
MN3 | V1 | Page 8
A
➡
CAB
DETAIL A
JACKNUT
JACKNUT
JACKNUT
WRENCH
PREP BED: DRILL CABSIDE HOLES
• Drill four 7/16" holes at marked locations using a drill stop set to 1/4."
• NOTE: To resist corrosion, seal the raw metal edges of the drilled holes with self-etching primer (available at
most auto supply or hardware stores).
• Install jacknut (yellow) onto jacknut wrench (orange) with 1" placement bolt; BAG PREP-MN3. NOTE: Do not use the
slightly shorter dogpoint bolts also found in your PREP BAG.
• DETAIL A: Insert jacknut into hole. While holding jacknut wrench, tighten bolt with 3/8" socket until jacknut
is fully crimped. Remove bolt.
• Repeat on the remaining three holes.
1" PLACEMENT BOLT
7/16” DRILL
BIT
DRILL
STOP
1/4”