Installation Guide

MT6 | V1 | Page 2
PREP BED: SHIMS
• 2 SHIMS that look like this can be found in your hardware kit.
• Using the information below:
1) Clean the bed surface where the shims will be located. Isopropyl alcohol (do not drink) is recommended.
2) Remove tape film and apply shim with the strength of 1000 men a.k.a push really hard.
DETAIL A
Align shim to channel in floor shown 3” from
cabside panel of bed (edge in red).
DETAIL B
Align shim to channel in floor shown. Place
shim 8” from rear of bed (edge in red).
3”
8”
A
B
➡
CAB