Installation Guide

MT6 | V1 | Page 5
NOTE: Do not attempt alone. Rock Paper Scissors for who lays on the ground to hold the backing plate.
VIEW FROM WHEEL WELL
PREP BED: CABSIDE BRACKET (2015CURRENT)
• Follow STEP 1 - STEP 2; BAG PREP-MT6.
• Repeat passenger side.
STEP 1
STEP 2
Remove factory cabside tie-down with a T30 torx driver. Keep bolts. Mark 1 3/8" up from lower factory hole center.
Mark 1 1/8" toward tailgate from factory hole centers. At center mark (green), drill a 5/16" hole using a 1/2"drill stop.
Install cabside bracket with the two factory tie-down bolts inserted in the oval
holes. Play Rock Paper Scissors with your pal. The loser needs to hold the backing
plate inside the wheel well. Install one 1" length x 5/16" diameter bolt through
center cabside bracket hole into backing plate and install with flanged nut.
NOTE: You'll have four extra 1" bolts and four nuts that you won't need in your
MT6 bag. Do with them as you wish.
➡
CAB
FACTORY TIEDOWN
1 3/8"
1 1/8"
➡
CAB
➡
CAB
➡
CAB
CABSIDE BRACKET
FACTORY BOLTS
Double check that you have a 2015 - current Tacoma with a cabside
factory tie-down. If you have an earlier model Tacoma with no cabside
factory tie-down, revert to page 4.
STOP:
BACKER PLATE GOES OUTSIDE THE
INNER PLASTIC BED ON THE INTERIOR
WHEEL WELL WALL... TRY SAYING THAT
THREE TIMES FAST.
5/16”
DRILL BIT
DRILL STOP
1/2”
FLANGED
NUT
NOTE: Do not attempt alone. Rock Paper Scissors for who lays on the ground to hold the backing plate.
1" LENGTH x
5/16" DIAMETER
BOLT