Installation Guide
MT6 | V1 | Page 6
PREP BED: TAILGATE BRACKET
NOTE: If your pal left, clank some cans together to get them to come back.
• Remove top rear factory compartment bolt from the driver side with a T30 Torx Driver. Keep bolt.
• Loosely attach driver side tailgate bracket with factory bolt in top hole. Make sure the tie down opening is angled
toward the driver, not the tailgate; BAG PREP-MT6.
• Align bracket so it's parallel with vertical edge of compartment. Tighten factory bolt at last!
• Using the bottom hole in bracket as a guide, drill a 5/16" hole with a 1/2" drill stop through compartment and bed wall.
• Install a 1" length x 1/4" diameter bolt and flanged nut in bracket and tighten securely; BAG PREP-MT6.
• Repeat passenger side.
NOTE: On passenger side ONLY, you will need to add a washer; BAG PREP-MT6...We know it's strange, trust us.
DRIVER SIDE
FACTORY BOLT
PASSENGER SIDE
HELPFUL TIP: Feel free to remove doors of cubbies
so you can still somewhat use them. Use will be
compromised, but hey, life ain't always fair, right?!
HELPFUL TIP: The power outlet can still be used if you
insert a flat head pigtail extension cord BEFORE you
install the decks. Make sure to have the outlet capped
to keep water out.
ANGLE TIEDOWN
TOWARD DRIVER
➡
CAB
➡
CAB
1" LENGTH x
1/4" DIAMETER BOLT
FLANGED
NUT
WASHER
FLANGED
NUT
REALLY OLD DRILL WE
FOUND ONLINE
1" LENGTH x
1/4" DIAMETER BOLT