Installation Guide

Recessed Lighting Kit Installation Instructions
Low voltage 8-piece LED light kit
IMPORTANT SAFETY INFORMATION PERTAINING TO
RISK OF FIRE OR INJURY TO PERSON.
• Donotinstallwithin10feet(3m)ofapool,spaorfountain.
• Donotlookdirectlyintothelight.
• Forusewith12-volt,low-voltageoutdoorlandscapelighting
 systemonly.
• Therearenoserviceablepartsinsidethepowersupplyunit.
 Donotdisassemble.
• PlugthepowersupplyunitdirectlyintoaGFCIreceptacle
thatismarked"wetlocation."
• Thetransformercansupportamaximumof24individual 
 lights.Werecommendusingamaximumof16lightsforbest
 performance.
Please note: The light system must be installed in accordance
with all local codes and ordinances. If you are experiencing
problems, contact a qualified electrician.
Step 1: Find a location for the transformer and photo sensor.
• Outdooruse,weather-resistant.
• Donotinstallthephotosensorbehindshrubs.
Thiswillaffectthephotosensor.
• Thephotosensorwillnotoperateproperlyif
installedtooclosetoalightsource.
Step 2: Mount the photo sensor.
Mountthephotosensorwiththeincluded
screwonawallwithinonefoot(30cm)of
theelectricaloutletwherethetransformer
willbeconnected(g.1).
*Alternatephotosensorinstallation:Ifthereisnoareawithin1foot
(30.5cm)ofthetransformertoinstallthephotosensor,itispossibleto
installtheextensionwiredirectlytothetransformerandtoinstallthe
photosensorbetweentheextensionwireandtherstlight.
Step 3: Position lights and run wire.
• Thewireshouldrunfromthephotosensortoeachlight,
withoutbeingcut.Donotrunthewirewithin10feet(3m)
ofapool,spaorfountain.
• Loosewireshouldbetiedupandkeptclearofwalking
pathsandawayfromchildrenoranimals.
• Connecttheextensionwireandalllightxturesend-to-end,
makingonelongwireconnection.Thisisthedistance
availablewhenpositioningyourlights.
Please note: Additional light and wire add-ons are available
in packs of two. Additional extension wire is available in 16.4’
length. These add-ons are compatible with and follow the same
installation steps as the lights and wire in the original kit.
• Mostcommonlightplacementsareonsteprisersto
illuminatestairs,oratonthedecksurfacetodelineate
extremitiesandilluminaterailingsorwalls.
• Positionthelightxtures,makingsurethattheextension
wirewillreachthephotosensor.Oncetheyareproperly
positioned,drilloutholesusingtheincluded1"drillbit.
Important note: Please make sure that you
have properly calculated your distances
and are confident of the positioning
of the lights before drilling holes.
extension wire
transformer
LED deck light
photo sensor
drill bit
1"
g.3
g.1
g.2
One Recessed Lighting Kit contains:
• Eight (8) LED deck lights
• One (1) transformer
• One (1) extension wire
• One (1) photo sensor
• One (1) drill bit
transformer
photo sensor
connector
light fixture
extension
wire
Illustration of fixture is for example only.
For more information, visit our Web site at: http://www.ufpi.com
Continued on reverse