Manualshelf

Instructions / Assembly

ManualsBrandsDeckoRail ManualsDeck Railing Systems6 ft. Pressure-Treated Aluminum and Southern Yellow Pine Preassembled Rail
123
Step 1: Measure the distance between posts and cut the rails to
size. For even spacing between the balusters and posts, be sure to
cut from both ends of rails.
Step 2: Place the moulded cap rail upside down on a flat surface.
Next, place one of the 2x4 rails into the moulded cap rail channel so
that the holes are facing up. Starting from either end, fasten the top
2x4 to the cap rail using the (7) 3" screws through holes 1, 2, 5, 8,
11, 14, and 15. If rails are trimmed, predrill any additional holes with
a 1/8" drill bit and insert the screw into the next nearest hole. (Fig. 1)
Step 3: Attach the support block on the bottom of the bottom 2x4
rail using the 4" screw. The support block installs under hole 8. If
your rail was not trimmed evenly from both sides, find the closest
hole to the center to secure the support block. If that hole has not
been predrilled, predrill with a 1/8" drill bit. (Fig. 1)
Step 4: Attach the (4) 2x4 DeckoRail
®
railing brackets to the posts
according to the included instructions.
Step 5: Attach the bottom 2x4 rail, with the holes facing up, using
the 2x4 DeckoRail railing brackets. Insert the balusters into the
predrilled holes. (Fig. 2)
Step 6: Attach the cap rail by aligning the holes to the baluster at one
end of the rail and working your way to the opposite end, ensuring
that all of the balusters are secured between the two rails. (Fig. 2)
This brochure is for illustration purposes only. Use of this product must be in accordance with all local zoning and/or building codes. Consumer assumes all risks and liability associated with the use
of this product. For details on safe handling and warranty information, go to UFPI.com/ptinfo.
©2013 Universal Forest Products, Inc. All rights reserved. WeatherShield is a registered trademark of Osmose Wood Preserving Company of America.
Matching stair rail kit available on HomeDepot.com
Internet #204430479
Tools Needed
• Drill/power screwdriver
• Miter or circular saw with carbide-tip blade
• Tape measure
• Carpenter’s level
• Carpenter’s pencil
• Safety glasses/goggles
• Gloves
Procedures
6 ft. Pressure-Treated Railing Kit with Aluminum Balusters
INSTALLATION INSTRUCTIONS
Cap
123 456789101112131415
StrRail2.pdf
Top Insert Rail
•
•
123 456789101112131415
Bottom Rail
•
Support Block
•
Fig. 1
Bottom Rail
Support Block
Railing Brackets
Balusters
Cap Rail
•
•
•
•
•
StrRail3.ai
Fig. 2
50415 Herbert Street, P.O. Box 129 • Granger, Indiana 46530 • 574.277.7670 • www.ufpi.com
WeatherShield is a registered trademark of Osmose Wood Preserving Company of America. ©2013 Universal Forest Products, Inc. All rights reserved. 7188_ENG_7/13

Summary of content (3 pages)