Instructions / Assembly

Post Caps
To attach each post cap style to the post, ap-
ply an exterior-grade construction adhesive
to the underside of the post cap and place
firmly on the post (see Figure 1).
Important: All solar post caps and lights
will need 24 hours of direct sunlight
to fully charge.
Solar Post Caps
To activate your new solar post cap:
1
Remove top by pressing inward on the side
of the clear lens, grasping the edge of the
top and lifting it off (see Figure 2).
2
Install the batteries.
3 Replace top by snapping onto side panels.
(Ensure the holes in the sides are matched
up with the stubs on the top.)
4
Your solar post cap light is now ready to be
attached to your post (see Figure 1).
Some solar post caps have on/off switches. If your cap includes an
on/off switch, make certain it’s in the “on” position when you plan
to illuminate your lights. Batteries are included with solar post caps
but may not be installed. Ensure batteries are seated firmly in place
when installed.
Solar Tiffany-style Post Caps
To activate your new Solar Tiffany-style Post Cap:
1
Remove the solar panel by lifting it straight up
from the top of the cap (see Figure 3).
2
Install the batteries.
3 Replace the solar panel.
4 Your Solar Tiffany-style post cap is now ready
to be attached to your post (see Figure 1).
Post and Stair Lights
1
Slide plastic lens back to separate from
top portion.
2
Open battery compartment.
3 Remove the plastic tab from the battery compartment to allow
connection to the terminal.
4
Ensure battery is firmly in place and switch is in “on” position.
5 Attach bracket to post using screws included in package.
6 Slide the Post and Stair Light onto the bracket.
PRESS TO
REMOVE
TOP
Solar
Panel
Figure 1
Figure 3
Figure 2
2
3
Thank you for your purchase. The following pages contain information
to help you install and maintain your post caps for years of enjoyment.
Installation Instructions
If your post cap is not listed here, please check for installation instructions
inserted in or printed on the package.