Installation Guide

This brochure is for illustration purposes only. Use of this product must be in accordance with all local zoning and/or building codes. Consumer assumes all risks and liability associated with the use of this
product. For details on safe handling and warranty information, go to UFPI.com/ptinfo.
©2013 Universal Forest Products, Inc. All rights reserved. WeatherShield is a registered trademark of Osmose Wood Preserving Company of America.
50415 Herbert Street, P.O. Box 129, Granger, IN 46530
574.277.7670
www.ufpi.com
7188 Stair_7/13
Cap
123 456789101112131415
StairRail2.ai
Insert Rail
•
•
g. 3
Bottom Rail
Railing Brackets
Balusters
Cap Rail
•
•
•
•
StairRail3.ai
g. 4
Step 2: Place the moulded cap rail upside down on a flat surface.
Next, place the top 2x4 rail with the notch on the same side as the
baluster holes into the moulded cap rail channel so that the holes
are facing up. Starting from either end, fasten the rails together
using the (7) 4” screws through holes 1, 2, 5, 8, 11, 14, 15. If rails are
trimmed, predrill any additional holes with a 1/8” drill bit and insert
the screw into the next nearest hole (fig. 3).
Step 3: Attach the (4) 2x4 DeckoRail railing brackets according to
the included instructions.
Step 4: Attach the bottom 2x4 rail, with the holes facing up, using
the 2x4 DeckoRail railing brackets. Insert the balusters into the pre-
drilled holes (fig. 4).
Step 5: Attach the cap rail by aligning the holes to the baluster
at one end of the rail and working your way to the opposite end,
ensuring that all of the balusters are secured between the two rails
(fig. 4).
Step 6: Fasten a support block at the center of the bottom rail to
the deck surface for spans greater than three feet (fig. 1).