Installation Guide

INSTALLATION INSTRUCTIONS
Step 5
Step 6
Bottom Rail
Railing Brackets
Balusters
Cap Rail
•
•
•
•
StairRail3.ai
fig. 4
Step 4
Attach the bottom 2x4 rail, with the holes facing up, using the
2x4 DeckoRail railing brackets. Insert the balusters into the
pre-drilled holes (fig. 4).
Attach the cap rail by aligning the holes to the baluster at
one end of the rail and working your way to the opposite end,
ensuring that all of the balusters are secured between the two
rails (fig. 4).
Fasten a support block at the center of the bottom rail to the
tread surface for spans greater than three feet (fig. 1).
©2016 Universal Forest Products, Inc. All rights reserved. DeckoRail is a registered trademark of Universal Forest Products, Inc. in the U.S.
Assembled in the USA with balusters from Mexico. UFP Windsor, LLC 15 East Walnut St., West Building, Windsor, CO 80550 7734_1/16
DeckoRail.com
THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO REPLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION OR
USE OF THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH THE
CONSTRUCTION OR USE OF THIS PRODUCT. THE CONSUMER OR CONTRACTOR SHOULD TAKE ALL NECESSARY STEPS TO ENSURE THE SAFETY OF EVERYONE INVOLVED IN THE PROJECT,
INCLUDING, BUT NOT LIMITED TO, WEARING THE APPROPRIATE SAFETY EQUIPMENT. UNIVERSAL FOREST PRODUCTS, INC., MAKES NO WARRANTY, EITHER EXPRESS OR IMPLIED,
AND SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.