Installation Guide

ManualsBrandsDeckoRail ManualsDeck & Porch Railings8 ft. Aluminum Cedar-Tone Southern Yellow Pine Deck Railing Kit

Step 1: Measure the distance between posts and cut the rails to

size. For even spacing between the balusters and posts, be sure to

cut from both ends of rails.

Step 2: Place the moulded cap rail upside down on a ﬂat surface.

Next, place one of the 2x4 rails into the moulded cap rail channel

so that the holes are facing up. Starting from either end, fasten the

top 2x4 to the cap rail using the (9) 3" screws through holes 1, 2, 5,

8, 11, 14, 17, 19 and 20. If rails are trimmed, predrill any additional

holes with a 1/8" drill bit and insert the screw into the next nearest

hole. (Fig. 1)

Step 3: Attach two support blocks on the bottom of the bottom

2x4 rail using 4” screws. The support blocks install under holes 7

and 14. If your rail was trimmed, divide the overall length by three

to determine support block spacing and install under the holes

closest to this measurement. If the holes have not been predrilled,

predrill with a 1/8” drill bit. (Fig. 1)

Step 4: Attach the (4) 2x4 railing brackets to the posts according

to the included instructions.

Step 5: Attach the bottom 2x4 rail, with the holes facing up, using

the 2x4 railing brackets. Insert the balusters into the predrilled

holes. (Fig. 2)

Step 6: Attach the cap rail by aligning the holes to the baluster at one

end of the rail and working your way to the opposite end, ensuring

that all of the balusters are secured between the two rails. (Fig. 2)

This brochure is for illustration purposes only. Use of this product must be in accordance with all local zoning and/or building codes. Consumer assumes all risks and liability associated with the use

of this product. For details on safe handling and warranty information, go to UFPI.com/ptinfo.

Tools Needed

• Drill/power screwdriver

• Miter or circular saw with carbide-tip blade

• Tape measure

• Carpenter’s level

• Carpenter’s pencil

• Safety glasses/goggles

• Gloves

Procedures

8 ft. Railing Kit with Aluminum Balusters

INSTALLATION INSTRUCTIONS

Cap

123 4567891011121314

StrRail2.pdf

Top Insert Rail

•

123 456789101112131415

Bottom Rail

•

Support Block

•

1516

1617181920

Fig. 1

Bottom Rail

Support Block

Railing Brackets

Balusters

Cap Rail

•

StrRail3.ai

Fig. 2

15 East Walnut St., West Building • Windsor, CO 80550 • 800-294-2171

DeckoRail is a registered trademark of Universal Forest Products, Inc. in the U.S.

Assembled in the USA with imported balusters. 8668_ENG_7/17