Installation Guide

Step 1
Installation Instructions
Note: For use with moulded rails in the horizontal
position. Pre-drill all screw holes to minimize
splitting.
Step 1
Measure the distance between two posts and
subtract 1/2”. Cut rails to this length. Attach a
connector to each end of the rail with two screws
through the pre-drilled holes.
Step 2
Set the rail at the desired height and check to
ensure it is level. Fasten with screws through the
pre-drilled holes.
HORIZONTAL RAIL BRACKET
INSTALLATION INSTRUCTIONS
Tools Needed
Drill/power screwdriver
Tape measure
Carpenter’s pencil
Safety goggles
Gloves
Items Included
(4) Brackets
(24) Screws
THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO REPLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION OR
USE OF THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH THE
CONSTRUCTION OR USE OF THIS PRODUCT. UNIVERSAL CONSUMER PRODUCTS, INC. DOES NOT PROVIDE ANY WARRANTY, EITHER EXPRESS OR IMPLIED, AND SHALL NOT BE LIABLE FOR ANY
DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.
Deckorail.com
©2017 Universal Forest Products, Inc. All rights reserved. DeckoRail is a registered trademark of Universal Forest Products, Inc., in the U.S.
9665_11/17
Step 2