Installation Guide

Recessed Lighting Kit Installation Instructions
Low voltage 8-piece LED light kit
IMPORTANT SAFETY INFORMATION PERTAINING TO
RISK OF FIRE OR INJURY TO PERSON.
• Do not install within 10 feet (3 m) of a pool, spa or fountain.
• Do not look directly into the light.
• For use with 12-volt, low-voltage outdoor landscape lighting
system only.
• There are no serviceable parts inside the power supply unit.
Do not disassemble.
• Plug the power supply unit directly into a GFCI receptacle
that is marked "wet location."
• The transformer can support a maximum of
24 individual lights.
Please note: The light system must be installed in accordance
with all local codes and ordinances. If you are experiencing
problems, contact a qualified electrician.
Step 1: Find a location for the transformer and photo sensor.
• Outdoor use, weather-resistant.
• Do not install the photo sensor behind shrubs.
This will affect the photo sensor.
• The photo sensor will not operate properly if
installed too close to a light source.
Step 2: Mount the photo sensor.
Mount the photo sensor with the included
screw on a wall within one foot (30 cm) of
the electrical outlet where the transformer
will be connected (fig. 1).
Step 3: Position lights and run wire.
• The wire should run from the photo sensor to each light,
without being cut. Do not run the wire within 10 feet (3 m)
of a pool, spa or fountain.
• Loose wire should be tied up and kept clear of walking
paths and away from children or animals.
• Connect the extension wire and all light fixtures end-to-end,
making one long wire connection. This is the distance
available when positioning your lights.
• Most common light placements are on step risers to
illuminate stairs, or flat on the deck surface to delineate
extremities and illuminate railings or walls.
• Position the light fixtures, making sure that the extension
wire will reach the photo sensor. Once they are properly
positioned, drill out holes using the included 1" drill bit.
Important note: Please make sure that you have properly
calculated your distances and are confident of the positioning
of the lights before drilling holes.
• Disconnect the lights from each other and insert each fixture
into its corresponding hole by feeding the two (2) wires first
then pressing the fixture firmly into the hole so that it fits tightly
against the surface. The bulbs are slightly angled, so make
sure they consistently point up or down
based on the desired orientation.
Repeat this step for all eight (8) lights.
• Connect the male end of the
extension wire to the "OUT"
connection of the photo sensor
extension wire
transformer
LED deck light
photo sensor
drill bit
1"
fig. 3
fig. 1
fig. 2
One Recessed Lighting Kit contains:
•
Eight (8) LED deck lights
•
One (1) transformer
•
One (1) extension wire
•
One (1) photo sensor
•
One (1) drill bit
transformer
photo sensor
connector
light fixture
extension
wire
Illustration of fixture is for example only.
For more information, visit our Web site at: http://www.ufpi.com
Continued on reverse