Installation Guide

Step 1 Install posts by attaching the aluminum base to the surface of the deck.
Position the post so the fastener will go into the floor joist, and make sure the
decking is firmly attached to the joist at the location of the posts. If necessary,
use wood blocking as reinforcement underneath the decking where the posts
are located. Fasteners that hold the post base to the surface should be able to
secure to joist or reinforcement braces, not just the decking itself. Note: When
installing aluminum post on top of a wood surface, screws must be lagged into
at least 3” of solid wood. 5/4” or 1 ½” deck boards do not provide sufficient
material for a safe installation. If necessary, add additional material to the
underside of the surface.(fig. 1)
Step 2 Position the post assembly onto the location where it will attached to
the deck. Four 11/32” diameter mounting holes are provided on the base. When
the final position is determined, mark the base hole locations. Remove the
post assembly and drill 15/64” holes in the marked locations into the deck and
reinforcement.
Step 3 Reposition the post assembly over the predrilled holes and insert the
fasteners (not included). (fig. 1) Recommended fasteners: 4 – 5/16” x 4” or
longer stainless steel lag screws.
Step 4 Finish by sliding a post base trim (optional) over each post for a finished
look. Note: Installing the post base trim prior to installing the bottom rail is
recommended. However, the two-piece design does allow the installer to add
the post base trim after the rail has been installed. To install, apply a thin line of
clear exterior construction adhesive to the inside of the post trim where it will
contact the post sleeve and snap into place around the base of the post sleeve.
Classic Post Installation Instructions
ALX CLASSIC POST
INSTALLATION INSTRUCTIONS
Tools and Items Needed
• Drill/power screwdriver
• Miter or circular saw
with carbide tip blade
• Marked speed square
• Carpenter’s level
• Carpenter’s pencil
• Adjustable wrench
or socket wrench for
bolts, etc.
• Safety glasses/
goggles
• Rubber mallet
• Tape measure
ALXPostInst.ai
Bolts (4)
Base
Plate
Additional
Blocking
ALX Classic Post
fig. 1
Contents
1 – Post
1 – Post base trim
1 – Post Cap
THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO REPLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION OR USE
OF THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH THE CONSTRUCTION
OR USE OF THIS PRODUCT. THE CONSUMER OR CONTRACTOR SHOULD TAKE ALL NECESSARY STEPS TO ENSURE THE SAFETY OF EVERYONE INVOLVED IN THE PROJECT, INCLUDING, BUT NOT
LIMITED TO, WEARING THE APPROPRIATE SAFETY EQUIPMENT. EXCEPT AS CONTAINED IN THE WRITTEN LIMITED WARRANTY, THE WARRANTOR DOES NOT PROVIDE ANY OTHER WARRANTY,
EITHER EXPRESS OR IMPLIED, AND SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.
©2012-2015 Universal Forest Products. Deckorators is a registered trademark of Universal Consumer Products, Inc. in the U.S. All rights reserved.
933 US Route 202 Greene, ME 04236-3466
8179 2/15
www.deckorators.com