Installation Guide

ManualsBrandsDeckorators ManualsLattice(Common: 2-in x 1-in x 8-ft; Actual: 1.875-in x 0.625-in x 8.03-ft) Cedar/Redwood Plastic Lattice Divider

• Deckorators plastic lattice can be cut and drilled using

standard tools.

• Use rustproof or rust-resistant fasteners to maintain the

beauty of your project over time.

• For a distinguished look, frame panels with plastic caps

and connect panels with plastic dividers (ﬁg. 1).

• Always allow a 1/4" gap between the lattice edge and

moulding for the panel to expand and contract with

temperature changes (ﬁg. 2).

• Lattice must be attached to a self-supporting structure or

frame. Suspend lattice from top row of fasteners.

• Along the top, predrill oversized holes every two feet

through both the moulding and lattice with a 1/4" drill bit

and fasten with screws. Do not overtighten screws.

• Along the sides and bottom, predrill oversized holes every

two feet through the moulding only and fasten with screws.

DO NOT overtighten screws (ﬁg. 3).

• DO NOT install lattice in a horizontal application. Without

proper support, lattice will be prone to sagging, rippling and

heat retention.

Deckorators lattice is a nonporous material. Coatings such as

paints and stains do not adhere well to the surface.

Installation Tips

Finishing

THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO REPLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION OR

USE OF THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH THE

CONSTRUCTION OR USE OF THIS PRODUCT. THE CONSUMER OR CONTRACTOR SHOULD TAKE ALL NECESSARY STEPS TO ENSURE THE SAFETY OF EVERYONE INVOLVED IN THE PROJECT,

INCLUDING, BUT NOT LIMITED TO, WEARING THE APPROPRIATE SAFETY EQUIPMENT. EXCEPT AS CONTAINED IN THE WRITTEN LIMITED WARRANTY, THE WARRANTOR DOES NOT

PROVIDE ANY OTHER WARRANTY, EITHER EXPRESS OR IMPLIED, AND SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.

1/4" gap

ﬁg. 1

ﬁg. 2

ﬁg. 3

8024_1/19

www.Deckorators.com

PLASTIC LATTICE INSTALLATION TIPS

Summary of content (1 pages)

PAGE 1
PLASTIC LATTICE INSTALLATION TIPS Installation Tips fig. 1 1/4" gap fig. 2 • Deckorators plastic lattice can be cut and drilled using standard tools. • Use rustproof or rust-resistant fasteners to maintain the beauty of your project over time. • For a distinguished look, frame panels with plastic caps and connect panels with plastic dividers (fig. 1). • Always allow a 1/4" gap between the lattice edge and moulding for the panel to expand and contract with temperature changes (fig. 2).