Use and Care Guide
Cleaning your Aluminum Railing or Balusters will minimize the effects of
weathering as well as remove soiling agents to enhance the appearance
of your railing.
Disregarding the following care and cleaning guidelines may void the
Deckorators ALX Railing and Baluster limited warranty. For warranty
claims where the product is installed within one mile of coastal salt
water, you are required to follow the cleaning guidelines and frequency
below, and keep a log detailing each cleaning date, method used and
detergent used.
1. For Railing or Balusters located within one mile of coastal salt water,
cleaning is required every three months.
2. For Railing or Balusters located more than one mile from coastal salt
water, cleaning is recommended every six months or at a minimum,
annually. The amount of surface soiling on your railing will vary
depending on geographic area and environmental conditions.
Cleaning may need to be more frequent to restore and maintain
the desired appearance in your area.
DETERGENTS
Most mild soaps and detergents ruled safe for bare hands are acceptable
for coated aluminum. Do not use any type of soap or detergent that
recommends gloves or respirators for personal protection. Do not use
any soap or detergent that could damage a painted finish. For example,
never use aggressive alkaline or acid cleaners, strong solvents, or abrasive
cleaners that could damage the surface.
The best time to clean the railing or balusters is in mild temperatures
and when the metal is shaded. Do not attempt to clean hot, sun-baked
metal surfaces. Also avoid cleaning in freezing temperatures or when
the metal is cold enough to cause condensation.
HAND WASHING INSTRUCTIONS
1. Wet the Deckorators ALX Railing and/or balusters with clean water.
2. Wipe down all surfaces with a non-abrasive sponge or soft cloth
using a mild detergent cleaning solution.
3. For best results start at the top of the railing or balusters and
work downward.
4. Thoroughly rinse the railing or balusters with clean water to
remove all cleaning solution and residue. In areas where water
has high mineral content, we recommend drying with a soft
lint-free cloth or chamois to avoid spotting.
PRESSURE WASHING INSTRUCTIONS
1. A mild detergent cleaning solution is recommended as a medium
to carry away dirt.
2. Use moderate pressure and a fan tip nozzle. Do not exceed
1,000 PSI and keep nozzle tip at least 18” from your railing or balusters
3. Wash all exposed surfaces
4. Thoroughly rinse with clean water to remove all cleaning solution
and residue. In areas where water has high mineral content,
we recommend drying with a soft lint-free cloth or chamois to
avoid spotting.
ALX CLEANING & CARE