Manualshelf

Installation Guide

ManualsBrandsDeckorators ManualsBuilding SuppliesRectangular Top Cable Rail, 92.5-in, Weathered Brown
123
ALX CONTEMPORARY CABLE RAILING
INSTALLATION INSTRUCTIONS
Tools and Items Needed
• Drill/power screwdriver
• Miter or circular saw with
carbide tip blade
• Marked speed square
• Carpenter’s level
• Carpenter’s pencil
• Adjustable wrench or
socket wrench for bolts,
etc.
Post Cap
•
Top Rail
•
•
Top Rail Bracket
Cable Spacer
•
•
Cable
2.5-in
Post
•
Post
Base
Trim
•
Leveling Plate
•
Cable Spacer Connector
•
(1) Top rail (2) Top Rail Brackets (8) Metal Screws (4) Large Screws (1) or (2) Cable Spacers (2) or (4) Cable Spacer Connectors (1) Cable Kit with Hardware
For 6’ On-Center or 8’ On-Center Line Railing:
• 1 Cable rail kit for each 6’ on-center or 8’ on-center section,
which contains:
1 - Top rail
2 - Top rail brackets
8 - Metal screws
4 - Large screws
1 - Cable spacer for 6’ on-center sections — 2 for 8’
2 - Cable spacer connectors for each cable spacer
• Cable posts, as needed per the deck layout
Available in End, Line, Corner, Mid-stair and Bottom Stair
• 10 Cable kits for each 36” height run or 12 for each 42” height run,
which contains:
1 - Cable with pre-attached threaded stud on one end, plastic spacer,
SS washer, brass locknut and cap
1 - Pull-lock fitting with Delrin washer and cap
Available in lengths of 5’, 10’, 15’, 20’, 25’, 30’, 40’ or 50’
In-Line Railing Installation Instructions
Prior to construction:
Check with your local regulatory agency for special code requirements
in your area. Common railing height is 36” or 42”. Pre-drill all screw holes
for best results. Read In-Line Railing instructions completely to get an
understanding of how the product goes together and how each piece
affects the other. Note: Use clean tools in order to reduce contamination on
stainless steel surfaces. We recommend using new chrome-plated tools
to protect the fittings from raw steel. Avoid installing with rusty tools, as
they leave rust deposits on the surface of the fittings. After installation, we
recommend cleaning the stainless steel parts completely with a stainless
cleaner and a soft clean rag in order to clear carbon deposits from the
surface.
• Safety glasses/
goggles
• Rubber mallet
• Tape measure
• Lag screws
• 3/16” allen wrench
fig. 1
fig. 3
fig. 2a
2.5-in
Corner Post
•
fig. 2b

Summary of content (3 pages)