Use and Care Guide

4 Your solar post cap light is now ready to be attached to your post
(see Figure 1).
Some solar post caps have on/off switches. If your cap includes an
on/off switch, make certain it’s in the “on” position when you plan
to illuminate your lights. Batteries are included with solar post caps
but may not be installed. Ensure batteries are seated firmly in place
when installed.
Solar Tiffany-style Post Caps
To activate your new Solar Tiffany-style Post Cap:
1 Remove the solar panel by lifting it straight up
from the top of the cap (see Figure 3).
2 Install the batteries.
3 Replace the solar panel.
4 Your Solar Tiffany-style post cap is now ready
to be attached to your post (see Figure 1).
Post and Stair Lights
1 Slide plastic lens back to separate from
top portion.
2 Open battery compartment.
3 Remove the plastic tab from the battery compartment to allow
connection to the terminal.
4 Ensure battery is firmly in place.
5 Attach bracket to post using screws included in package.
6 Slide the Post and Stair Light onto the bracket.
Solar
Panel
Figure 3
3