Specification

STEP 2: Remove the cut board and the fastener that
was screwed through that board.
Step-by-step Directions:
1. Remove the center piece that was cut in the previous step.
2. Remove side sections of board (the side that the screw is
running through will have to be pried out).
3. If screw breaks, pound ush into joist with hammer.
STEP 1: Cut the board that needs to be
replaced down the center. If tight, making two
cuts can help you remove the center portion of
the board more easily.
Step Hint:
Use a circular saw to make the two center
cuts on the deck board that is to be removed.
Board Replacement Step By Step
STEP 3: Run a screw at a 45° angle into the groove
that you removed the DeckWise® fastener from.
STEP 4: Carefully slide a new deck board onto
the exposed DeckWise® fastener.
STEP 5: Countersink a screw straight down into the side of the
board that has no fastener and use a wood plug over the hole.
Step Hint:
Installing a board with a groove on just one
side of the deck board is optimal in this step.
Step Hint:
If installing a deck board with grooves on both
sides of the deck board, make sure not to drive
the face driven screw through the groove.
20