MSDS

FLASH POINT: Non-Flammable
AUTOIGNITION TEMPERATURE: Not Applicable
FLAMMABLE LIMITS (in air by volume, %): Lower NA; Upper NA
FIRE EXTINGUISHING MATERIALS: Use agent most appropriate to extinguishing
surrounding fire.
UNUSUAL FIRE AND EXPLOSION HAZARDS: None Known
Explosion Sensitivity to Mechanical Impact: Not Sensitive
Explosion Sensitivity to Static Discharge: Not Sensitive
SPECIAL FIRE-FIGHTING PROCEDURES: Incipient fire responders should wear eye
protection. Structural firefighters must wear Self-Contained Breathing Apparatus and full
protective equipment. Isolate materials not yet involved in the fire and protect personnel.
Move containers from fire area if this can be done without risk; otherwise, cool with
carefully applied water spray. If possible, prevent runoff water from entering storm drains,
bodies of water, or other environmentally sensitive areas.
NFPA RATING
FLAMMABILITY
HEALTH REACTIVITY
OTHER
Hazard Scale: 0 = Minimal 1 = Slight
2 = Moderate
3 = Serious 4 = Severe
6. Accidental release measures
SPILL AND LEAK RESPONSE: Absorb spill with inert material (e.g. vermiculite, sand, or earth), then place in suitable container for disposal. Clean up
spills immediately, observing precautions.
US Regulations (CERCLA) require reporting spills and releases to soil, water and air in excess of reportable quantities. The toll free number for the US
Coast Guard National Response Center is [phone].
DISPOSAL: Dispose of in accordance with applicable Federal, State, and local procedures (see Section 13, Disposal Considerations).
7. Handling and storage
WORK PRACTICES AND HYGIENE PRACTICES: Wash thoroughly after handling this product. Do not eat, drink, smoke, or apply cosmetics while
handling this product.
STORAGE AND HANDLING PRACTICES: Avoid contact with eyes. Store in a tightly sealed container. Store in a cool, dry, well ventilated area.
Protect from physical damage.
8. Exposure controls - personal protection
VENTILATION AND ENGINEERING CONTROLS: Use with adequate ventilation to ensure exposure levels are maintained below the limits provided
below. Use local exhaust ventilation, and process enclosure if necessary, to control airborne dust. Ensure eyewash/safety shower stations are available near
areas where this product is used.
EXPOSURE LIMITS/GUIDELINES
Component Name: CAS # ACGIH TLVs OSHA-PELs NIOSH-TLVs Other
Acrylate Polymer Solution 28205-96-1 Not Listed Not Listed Not Listed Not Listed
Non-Hazardous Colorants Non-Hazardous Mixture Not Listed Not Listed Not Listed Not Listed
Titanium Oxide 13463-67-7 Not Listed Not Listed Not Listed Not Listed
Diethylene Glycol 111-46-6 Not Established Not Established Not Established MAK: 10 ppm; 44 mg/m³
Kaolin 1332-58-7 Not Listed Not Listed Not Listed Not Listed
Glycol Ether 29911-28-2 Not Listed Not Listed Noth Listed Not Listed
Water 7732-18-5 Not Listed Not Listed Not Listed Not Listed
International exposure limits may be established for the components of this product. Please check with competent authority in each country for the most
recent limits in place.
The following information on appropriate Personal Protective Equipment is provided to assist employers in complying with OSHA regulations found in 29
CFR Subpart I (beginning at 1910.132) or equivalent standard of Canada, or standards of EU member states (including EN 149 for respiratory PPE, and EN
166 for face/eye protection), and those of Japan. Please reference applicable regulations and standards for relevant details.
0
-1--. . ---0
-
-
SAFETY DATA SHEET
Page 3 of 6