Installation Guide

Customer Service: 561-274-2110

www.decolav.com

LET YOUR DREAMS COME ALIVE, YOUR PASSIONS

BECOME REALITY, BE THE ENVY OF YOUR NEIGHBORS

WALL CABINET INSTALLATION

INSTRUCTIONS

• DO NOT clean the product with Detergents, Acid, Abrasives, Harsh Cleaners or a cloth with a coarse surface (S.O.S.

Pads, Scotch Brite

Pads).

This is good advice for any plumbing  xture regardless of material.

•

DO NOT allow your DECOLAV

product to unnecessarily encounter other solid objects.

•

DO clean your DECOLAV

product. Wipe with a damp cloth and dry with a soft cloth. If necessary, a general mild soap and water solution can

be used. Use a mild furniture polish to clean wood frame.

•

DO clean your DECOLAV

mirror. Wipe with a glass cleaner and a clean soft cloth. Use a mild furniture polish to clean wood frame.

CARE AND CLEANING

RECOMMENDED TOOLS

NOTE: Due to vast di erence in building materials, wall anchors and screws are not provided but are recomended throughout instructions.

STEP #1

o Determine at what height the wall cleat is to be hung. Mark with pencil.

o Using a level make a horizontal line where the mirror is to be hung that is parallel to the  oor.

o Place the wall cleat on this line in the desired location and mark for the drywall anchor holes (Note: if a hole

will hit a wall stud use a screw instead of a drywall anchor).

o Bore holes for the drywall anchors per manufactures recommendation and install drywall anchors.

o Attach the wall cleat to the wall by passing screws through the cleat and into the drywall anchor.

Tape Measure

Phillips

Screwdriver

Drill

Level Pencil

Wall Cleat

Screw or Wall Anchor

Finished Wall

Figure A

PAGE 1
WALL CABINET INSTALLATION INSTRUCTIONS 1 CARE AND CLEANING ® ® • DO NOT clean the product with Detergents, Acid, Abrasives, Harsh Cleaners or a cloth with a coarse surface (S.O.S. Pads, Scotch Brite Pads). This is good advice for any plumbing fixture regardless of material. ® • DO NOT allow your DECOLAV product to unnecessarily encounter other solid objects. ® • DO clean your DECOLAV product. Wipe with a damp cloth and dry with a soft cloth.
PAGE 2
WALL CABINET INSTALLATION INSTRUCTIONS 2 STEP #2 o Raise Wall Cabinet above wall cleat and lower into position so that the cleat that is installed by the factory contacts the cleat previously mounted on the wall in Step #1. Carefully lower into position. o Push down on the top of the Wall Cabinet to ensure the Wall Cabinet cleat and the wall cleat is fully seated into position. The Wall Cabinet should be fully against the wall when cleats are fully seated.
PAGE 3
WALL CABINET INSTALLATION INSTRUCTIONS 3 Figure E ADJUSTING THE HINGES o The rear screw will move the door closer to the end panel or away from the end panel. If the door is rubbing the end panel, use this adjustment screw. Remember to adjust both hinges on the door for the desired clearance. o To get the doors even across the top and bottom edges of the doors use the side to side adjustment screw. Remember to adjust both hinges on the door for the correct position.