DS2 Setup Guide

Dedicated Micros ©2007
46
DS2
Base PPP IP address
PPP Link 1 IP address
PPP Link 2 IP address
PPP idle line timeout
PPP link down timer
010.001.001.241
010.000.000.001
010.000.000.002
180 Seconds
02 Minutes
Disabled, Enabled
000 - 500 Seconds
00 - 60 Minutes
PPP
S
election
PPP IP
Enter the IP address allocated to the PPP functionality. Use the and buttons to scroll through
the available numbers.
NOTE:
The IP address dened here is the base PPP IP address. The IP address used for dial in to
the PPP_Link2 is one greater than this ie if a PPP IP address is dened as “10.0.0.1” in the
PPP Selection menu, the IP address associated with PPP_Link2 is “10.0.0.2”.
PPP Link 1 & 2 IP addresses
These are read only parameters and identify the outgoing (alarm notication) and incoming (remote
viewing) IP address for the PPP function. The Outgoing IP address will automatically take the IP
address set in the Base IP address section. The incoming IP address will be the next consecutive
IP address in the sequence, example 10.0.0.1 base IP address will be the outgoing IP address, the
incoming IP address will be 10.0.0.2.
PPP Idle Line Timeout
This is the time the unit will wait before disconnecting the PPP link if no data is being transmitted or
received.
PPP Link Down Timer
This is the time the unit will wait before dropping the PPP connection should it be lost.
Viewing Resolutions
Standard recording
High Viewing
Medium Viewing
Low Viewing
Description
Parameters
MPEG
MPEG 12
MPEG 05
MPEG 08
2CIF MED
704x256 0090Kb/s 02PPS
JPEG
High
704x256 25KB
352x256 18KB
352x256 08KB
Network Viewin
g
Resolutions
Standard Recording
This shows the system standard recording format as previously congured, this option is read only
and can not be edited.