DS2 Setup Guide

DS2

IP Camera Setup

Camera X

This is the input into the back of the unit. Since this video feed will be via the network, select a

channel that does not have a physical connection.

Type

The unit can recognise a range of IP cameras as well as digital video feeds from NetVu Servers.

These include;

NetVu Server Axis 2120 Axis 206

Axis 211 Axis 2140 Axis 211A

AL9710 JVC VN-C20 Axis 214

JVC VN-C625 JVC VN-C655 Axis 233H

Note: Other cameras utilising the same stream/telemetry protocol as those listed above

will also be supported.

URL

Enter the IP address that will send the IP stream

Port

Enter the port number to be used for this stream.

Camera Number

If a NetVu Server is being used, this parameter will specify which camera number from the Server

will be used to provide the stream.

FPS

Enter the frames per second that the camera has been set to deliver.

Colour Adjust

When the colour bar is selected, press to reduce, and to increase the colour. This option is not

available for IP Cameras.

Note:

This option is not displayed if the camera is set as monochrome.

Contrast Adjust

When the contrast bar is selected, press to reduce, and to increase the contrast. This option is

not available for IP Cameras.

Camera Video Input

This option is only displayed when a camera has failed or is ofine. Select disconnect whilst the

camera is ofine to prevent the camera fail message and alarm being triggered.

If the video input is not to be monitored for camera failure select Connected - Ignore cam fail.

Tip:

This menu can be entered directly by pressing and holding a camera button.

Telemetry

The unit supports control of coaxial and serial telemetry. This option allows the connected dome/PTZ

camera to be congured.