Operating instructions

DV-IP RT

Gb Network

This menu allows the IP, Subnet and Gateway details to be congured for the 1Gb network

connection. Utilising the Gb Network via Network port 1 on the unit, labelled ‘NET 1’.

Note: Any xed IP address assigned to the 1Gb Network connection must NOT be the same

address as that assigned to the 100BaseT connection as displayed in Network Settings-

>Network->IP Address.

IP Address This is the IP address allocated to the unit.

Sub Net This is the subnet of the network were the unit is located.

Gateway This is the IP address of the default gateway (router).

DHCP The unit is set to default to DHCP. The unit can be installed in a

DHCP network environment where an IP address, subnet mask

and default gateway will automatically be allocated from the

network DHCP Server. It is recommended that this be disabled

as the DHCP address is automatically allocated from a pool of

available IP addresses on power up. If the unit loses power,

the connection could reset to a different number. Setting the IP

address disables DHCP.

Max Transmission Rate

kbytes sec

This shows the maximum transmission speed for the network type

being used.

Tx Image Buffers This is used in order to improve the picture delivery over Ethernet

when using a slow connection i.e. 256Kbps. A buffer setting of 1,2

or 3 is available.

Ethernet MTU Bytes This is the maximum transmit unit for the Ethernet packet. The

MTU is the largest physical packet size measured in bytes that the

network can transmit. By default this gure is set to 1500bytes.