Operating instructions

SD Advanced

The unit can automatically transmit an email to an SMTP Server under numerous conditions i.e. on

start up, on receipt of an alarm, camera failure etc. This allows the unit to be installed in unmanned

applications where a Remote Video Response Centre (or Manager etc.) would be notied by email if

any of these conditions occur.

Connection Prole It is possible for the email to be transmitted via the Ethernet

network or dial up connection (PPP ‘Point to Point Protocol’).

This setting presumes that a modem has been connected or

congured and the unit is connected to a LAN or WAN and

allocated a valid IP address.

Mail Server Address This is the IP address or URL of the SMTP Server that the email

will be sent to. The SMTP server will then forward this to the

intended recipient.

Recipient Email This is the email address of the intended recipient.

Recipient Display Name This is the addressee name that will be shown in the email name

eld.

Reply to Email This eld must be congured if the recipient is to reply to an email.

The unit does not accept incoming emails therefore ensure this is

a valid email address.

Reply To Display Name This is the ‘reply to’ name that will be shown in the email

name eld.