Installation manual

E.g. To add another control input to the unit, wire it into the terminal block marked with CTRL I/P 2
then set switch bank switches 6 and 7 on. When the contacts on the input switch are closed the
light will come on, if you want the light to come on when the input contacts are open then set bank
switch 7 to off.
If multiple switches are connected the light will switch on when any of the switches are on (OR
control).
Dennard 2025 Installation Manual Page. 13
No.. Description ON= OFF= Factory Setting
1
POWER CONTROL 1
SEE POWER SETTINGS TABLE OFF
2 UNUSED OFF
3 ENABLE CONTROL
INPUTS
ALWAYS IN ON
POSITION
- ON
4 CTRL I/P 1 ENABLE
(PHOTOCELL)
INPUT ENABLED INPUT DISABLED ON
5 CTRL I/P 1 TYPE
(PHOTOCELL)
CLOSED SWITCH
INPUT = ARRAY ON
OPEN SWITCH
INPUT= ARRAY ON
ON
6 CTRL I/P 2 ENABLE INPUT ENABLED INPUT DISABLED OFF
7 CTRL I/P 2 TYPE CLOSED SWITCH
INPUT = ARRAY ON
OPEN SWITCH
INPUT= ARRAY ON
OFF
8 CTRL I/P 3 TYPE INPUT ENABLED INPUT DISABLED OFF
9 CTRL I/P 3 TYPE CLOSED SWITCH
INPUT = ARRAY ON
OPEN SWITCH
INPUT= ARRAY ON
OFF
10 POWER CONTROL 2 SEE POWER SETTINGS TABLE OFF