Installation manual

Dennard 2025 Installation Manual Page. 5
5. General Safety Information
This Dennard 2025 equipment shall only be installed by qualified service personnel.
The final installation must adhere to all national wiring regulations.
The disconnect device must comply with IEC 60947.
WARNINGS
Read instructions before installing and power up.
Instructions should be kept for future reference.
If this unit shows signs of damage or malfunction, disconnect from mains immediately and contact
Dedicated Micros.
6. Mounting the Illuminator
Ensure the illuminator is mounted in a well ventilated area with over 100mm clearance around the
heatsink on all sides.
Avoid mounting the illuminator in direct sunlight or next to other heat sources.
Failure to provide this will shorten the life of the LEDs and decrease the lamp brightness.
WARNING: Ensure the illuminator is mounted a minimum of 2m away from eye level. Do not
look directly at the illuminator for prolonged periods during use.