Installation manual

7. Mounting to a Dennard 2000 Pan and
Tilt Unit
Figures 2 and 3 show typical positions for I.R. illuminators when mounted to a remotely controlled
Dennard 2000 pan and tilt head.
Mount the Dennard 2025 illuminator using the M10 fixings supplied with the unit.
Due to the weight of the Dennard 2025 it is not recommended that it is used with the optional side
mounting plate on the pan and tilt unit.
8. Mounting to a wall
The illuminator can be mounted directly to a wall to allow up and down adjustment only.
Alternatively it can be mounted using the wall mounting bracket provided which also allows left to
right adjustment. See Fig. 4.
WARNING: Ensure the wall fixings used are suitable for the type of wall and can support the
full weight of the unit.
9. Mounting the Control Unit
Remove the sealing plugs as shown in Fig. 5 and then use the rawlplugs, screws and rubber
washers provided to mount the control unit to the wall. Use silicon sealant between the wall and
unit to ensure a water tight seal is maintained.
Dennard 2025 Installation Manual Page. 6