Installation manual

2060

Tile Mounting - Indoor Dome

Ø190mm

3 x Ø6mm

204mm PCD

1. Remove the selected tile that will have the dome mounted to it. Use the mounting

ring (B) as a template to mark the drilling positions of the 3 x supporting holes on

a 204mm pitch circle diameter (6mmØ holes, if using the supplied cavity plugs (A))

and the 190mmØ hole for the dome. Fit the cavity plugs (A) to the holes.

Note: The installer is responsible for ensuring the xings used to mount the dome are suitable for

the material and will adequately support the weight of the dome.

2. Attach the mounting ring to the dome using the provided 6 x M3x8 xings (C).

3. Re-install the tile in the ceiling. Secure and hang the dome to a suitable mounting

point in the ceiling void by attaching the safety bond spring clip to the eyelet

(through the large centre hole in the tile).

Note: Ceiling installation is made easier by removing an adjacent ceiling tile during installation.

4. Fasten the dome to the mounting ring (B) using the provided 3 x No.8x1”(25.4mm)

self tapping screws (D) (or suitable xings provided by the installer).

5. Snap t the tile mount bezel (E). This replaces the standard bezel (F) provided with

the camera. Discard the standard bezel (F).

Note: If the dome requires tile mounting Part E must be ordered separately using part number

DM/CSD/TMR.