Installation manual

2060

Switch Conguration - Indoor and

Weatherproof Domes

The same address switches are used for both RS485 and up the coax control.

Up the Coax Conguration

Switch settings

The switches are color coded, blue and yellow, and are located inside the dome camera housing.

Congure the switches for the controller being used as shown in table below.

Note: The switches are factory set to FD (DM up the coax control).

Up the Coax Switch Conguration

Control Blue Yellow

DM/Dennard up the coax F D

Pelco Coaxitron up the coax F 8

Baxall AC controllers F C

Baxall DC controllers F E

For up the coax control using external protocol convertors or alarm interfaces such as RX100 or

AL008, the address switches should be set to Blue - 0 Yellow - 1.

RS485 Serial Connection

The coax cable and power wires are always connected.

The RS485 wires are only connected when an RS485 controller is being used.

The dome supports a range of serial RS485 PTZ protocols. The desired protocol and the node

address for the dome are selected by the two rotary hex switches (blue and yellow) inside the

dome. These are accessed by removing the outer hemisphere and inner shroud, refer to Switch

Conguration for more information.

The switch settings for the protocols and node addresses are shown in the table below.

To use the table;

1. Select the protocol required

2. Select the node address of the dome to be congured.

3. Scan across the table to identify the values for the blue and yellow switches.

For example, if the dome is to be used with a Dedicated Micros PTZ controller system with address

ID#5 the switches should be set to ‘05’. i.e. the blue switch should be set to ‘0’ and the yellow switch

set to ‘5’.