Installation Manual

Installation Dedrone
12 v0.4 IM-Inst-RF160en
10
Place the RF-160 on the pole mount
• Slide the fixing screws in the screw guides
of the mounting plate (1). Thereby make
sure that the two flaps of the pole mount
slides in the slot of the RF-160.
• Tighten the security screw by hand (2).
Thereby the sensor is secured from falling
down.
1
2
• Tighten the fixing screws appropriately.
Only use the supplied screws.
11
To connect the RF-160 to your local network,
connect the patch cable with the outdoor
housing to the network socket:
• Remove the protective cap from the plug.
• Plug the Ethernet cable with the outdoor
housing into the plug (1). Make sure that
the plug orientation fits the socket.
• Rotate the housing until it is locked (2).
• Lay the cable in the cable guide (3).
If you want to operate the RF-160 via
PoE+, make sure that PoE+ (802.3at) is
enabled on the connected switch.
] If the patch cable is connected to the net-
work and PoE+ is activated, the RF-160
boots automatically and after approxi-
mately 1 second the blue button at the
RF-160 illuminates, indicating that the
hardware is ready.
\ The patch cable is connected to the net-
work with activated PoE+ and the RF-160
does not boot automatically after appro-
ximately 1 second?
E Push the blue button and wait for it
to illuminate.
E Make sure that active PoE+ (802.3at)
is activated in your network.
E If you do not want to operate the
RF-160 via PoE+, connect the AC cable
as described in the next step.
2
3
1