Specifications

F20 Introduction
1.6 FCC Statement
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause undesired
operation.
RF Exposure Information (SAR) :
This device meets the government's requirements for exposure to radio waves. This device is designed and
manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by thethe
Federal Communications Commission of the U.S. Government.
The exposure standard for wireless devices employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. *Tests for SAR are conducted using
standard operating positions accepted by the FCC with the device transmitting at its highest certified power
level in all tested frequency bands.
Although the SAR is determined at the highest certified power level, the actual SAR level of the device while
operating can be well below the maximum value. This is because the device is designed to operate at
multiple power levels so as to use only the poser required to reach the network. In general, the closer you
are to a wireless base station antenna, the lower the power output.
when worn on the body, as described in this user guide, is 1.31 W/kg (Body-worn measurements differ
among devices, depending upon available enhancements and FCC requirements.) While there may be
differences between the SAR levels of various devices and at various positions, they all meet the
government requirement. The FCC has granted an Equipment Authorization for this device with all reported
SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information
on this device is on file with the FCC and can be found under the Display Grant section of http://
www.fcc.gov/oet/fccid after searching on FCC ID: ZD3FTF20SC200RNA.
For body worn operation, this device has been tested and meets the FCC RF exposure guidelines for use
with an accessory that contains no metal and the positions the handset a minimum of 0 cm from the body.
Use of other enhancements may not ensure compliance with FCC RF exposure guidelines. If you do not use
a body-worn accessory, position the handset a minimum of 0 cm from your body
is switched on at its highest certified power level in all tested frequency bands.