User Guide

FOR INSTALLATION ON DRIVER'S SIDE ONLY
PARTS LIST:
ITEM
QTY
THREAD LOCK TUBE 1
SHOCK 1
TOP
BALL MOUNT PLATE 1
BOTTOM
BALL MOUNT PLATE 1
BLIND NUT TOOL 1
BLIND NUT / NUTSERT 1
MYLAR 1
TOOLS REQUIRED:
10MM WRENCH
13MM WRENCH
M4 ALLEN WRENCH/SOCKET
M5 ALLEN WRENCH
TAPE MEASURE
PLIERS
NOTE: THIS PRODUCT CAN ONLY
STEP 2)
BE INSTALLED ON THE
Using a M5 Allen wrench and a 10mm wrench, install the blind nut in the opening by the tailgate pivot point.
DRIVER'S SIDE.
The nutsert should be tightened at least nine 360 degree turns. Mark one side of the nut and count the
number of revolutions to insure the correct number of turns. After the nine turns, if the blind nut can still be
STEP 1)
moved or rotates, continue tightening an additional 1 - 2 turns. Re-check blind nut, repeat as needed.
Adjust the nutsert tool so
there is 3/4" from the washer
Remove the nutsert tool when installation is complete.
WARNING:
to the head of the bolt.
Overtightening the nutsert
can strip the threads and cause
the nutsert to be unusable.
DZ 43102
TAILGATE ASSIST
CHEVY 2007-CURRENT
DO NOT TURN
DZ 43101 6/17/2015