Instruction Manual

DZ1030.PDF 06/02/99 PAGE 5

12a

12b

7/16“

Drill two 1/4“ holes up through the bottom of britetread

running board (A) at each angle brace (D) location, using the

holes in angle brace (D) as a guide.

Secure angle brace (D) to the britetread running board (A) using 1/4 x 1“ ribneck

carriage head bolts (M), 1/4“ flat washers (T), and 1/4” hex nuts (S).

Place mounting brackets (E) up to the vehicle

frame and angle braces (D) as shown. Drill two

1/4“ holes through the frame, using the

mounting bracket (E) as a guide.

Note: Repeat this process for all of

the angle brace placements.

Secure each mounting bracket (E)

into place using 1/4 x 3/4“ hex head bolts (P),

1/4” flat washers (T), and 1/4“ hex nuts (S).

Note: Repeat this process for all of the angle

brace placements.