Before returning this product to the store of purchase Contact Dee Zee if you experience the following problems: • Missing Parts • Installation Problems/Questions • Warranty Questions 1.800.779.2102 Hours of operation: 8am - 5pm CST, Mon-Friday Review complete warranty policy and register your product at: www.deezee.
Dee Zee Running Board Installation Instructions Congratulations on your purchase of a quality Dee Zee product. Dee Zee is recognized as having the highest quality running boards and accessories on the market today. We have earned this reputation by offering our customers a product they can be proud to place on their vehicles. Dee Zee meets all the criteria of manufacturing a custom-fit product which guarantees it to be the easiest product to install.
BRITE TREAD RUNNING BOARD INSTALLATION INSTRUCTION DZ 1057 CHEVY REGULAR CAB 2014-CURRENT DZ 1060 GMC REGULAR CAB 2014-CURRENT RUNNING BOARD A VARIES FRONT BRACE B X1 LH/ X1 RH B 2161LP/RP REAR BRACE C X1 LH/ X1 RH D THIS SPACE INTENTIONALLY LEFT BLANK B 2162LP/RP E FP0200 I PN 97 DZ 1057 MUD FLAP F X2 GSK-41 SHEET METAL SCREW J X4 PN 72 X1 LH/ X1 RH BULB GASKET G 9.5 FT.
TOOLS REQUIRED WRENCH/RATCHET TORQUE WRENCH CLAMP 21mm, 3/8", 7/16" TIN SNIPS 1 Locate the 2 mounting locations. The driver's side is shown. The front of the vehicle is to the left of the picture.
2 Remove the bolt from the body shock mount at each of the mounting locations using a 21mm socket.
3 Put the body shock mount bolt through the hole in the brace and thread it back into the body shock mount. Align the braces so that they are perpendicular to the side of the vehicle. Tighten the bolts to 44 ft-lbs plus another half turn. The driver's side is shown. The front of the vehicle is to the left of the pictures.
4 Place the bulb-seal gasket [F] onto the backlip of the runing board [A]. Cut the bulb-seal gasket with tin snips so that it is flush with the ends of the board 5 Loosely attach the mud flap [E] to the end of the running board using the 1/4" x 3/4" hex head bolt [H], the 1/4" flat washer [J], and the 1/4" hex nut [K]. Snug the bolts, but do not completely tighten at this time.
6 Place the running board on the braces with the bulb seal up against the bottom of the vehicle. BULB SEAL AGAINST Align the board with the vehicle and make sure that the mud flap is up against the wheel well.
7 Using the slots in the brace as a guide, drill a 1/4" hole at each mounting location. Clamp the board to the brace to hold it in position. 8 Attach the running board to the angle brace using the 1/4" x 1" ribneck carriage bolt [G], 1/4" flat washer [J], and 1/4" hex nut [K]. Tighten using a 7/16" wrench or deep well socket.
9 10 Pressing the flap up against the wheel well, drill two 3/16" holes through the hole in the mud flap into the sheet metal of the wheel well. Attach the mud flap to the wheel well using two sheet metal screws [I] with a 3/8" socket. Repeat for the rear of the board. Check all hardware to make sure it has been tightened. Repeat the assembly steps for the other side of the vehicle.