INSTALLATION INSTRUCTIONS BENT END SIDEBARS 09-12 FORD F-150 REGULAR CAB PART # DZ 372331/DZ 372332/DZ 372333
BENT END SIDEBARS 09-11 FORD F-150 REGULAR CAB PARTS LIST: 1 1 1 1 2 1 1 1 1 2 2 4 2 4 4 Driver/Left Sidebar Passenger/Right Sidebar Driver/Left Front Mounting Bracket Passenger/Right Front Mounting Bracket Support Brackets Driver/Left Top Mounting Bracket Passenger/Right Top Mounting Bracket Driver/Left Rear Mounting Bracket Passenger/Right Rear Mounting Bracket 12mm x 40mm x 10mm Nut and Bolt Plate 12mm x 40mm Bolt Plates 12mm Plastic Retainers 10mm Plastic Retainers 1/2" x 2” Hex Bolts 1/2” x 1-1/4” OD
BENT END SIDEBARS 09-11 FORD F-150 REGULAR CAB OD x 2mm Large Flat Washers up from below and secure with (2) 8mm x 16mm OD x 1.6mm Small Flat Washers, (to clear the bracket), (2) 8mm Lock Washers and (2) 8mm Hex Nuts, (Figure 2). Do not tighten hardware at this time. 4. Next, locate the round and square holes in the floor panel next to the body mount. Select (1) 12mm x 40mm x 10mm Nut and Bolt Plate and thread (1) 12mm Plastic Retainer part way onto it, (Figure 3A).
BENT END SIDEBARS 09-11 FORD F-150 REGULAR CAB Driver Side Installation Pictured (2) 8mm x 30mm Hex Bolts (2) 8mm Lock Washers (2) 8mm x 24mm Large Flat Washers (outer) (2) 8mm x 16mm Small Flat Washers (inner against Bracket) (2) 8mm Hex Nuts Fig 1B Front Fig 1A Front Remove these two hex bolts and metal clip nuts.
BENT END SIDEBARS 09-11 FORD F-150 REGULAR CAB Driver Side Installation Pictured Front (1) 10mm x 35mm Hex Bolt (2) 10mm Large Small Washers (1) 10mm Lock Washer (1) 10mm Hex Nut Fig 7A Fig 6 Rear Rear Fig 7B Fig 8A 12mm Bolt Plate 12mm Plastic Retainer 12mm Flat Washer 12mm Lock Washer 12mm Hex Nut 10mm x 35mm Hex Bolt 10mm Plastic Retainer (2) 10mm Flat Washers 10mm Lock Washer 10mm Hex Nut (Fig 8B) Rear bolt on Rear Mounting Bracket pictured from outside of vehicle.
