INSTALLATION INSTRUCTIONS REAR LADDER 07-10 FJ CRUISER PART # DZ 760613/DZ 760611
REAR LADDER 07-10 FJ CRUISER PARTS LIST: 1 1 1 4 1 4 4 4 5 5 5 10 Step Ladder Lower Mounting Bracket Upper Mounting Bracket 6mm Metal Inserts 6mm Insert Tool 6-1.00mm x 20mm Hex Bolts 6mm Lock Washers 6mm ID x 22mm OD x 2mm Flat Washers 8-1.25mm x 20mm Hex Bolts Upper Mounting Bracket 6mm Insert Tool pictured with Insert and hardware Lower Mounting Bracket 8mm Lock Washers 8mm Hex Nuts 8mm ID x 16mm OD x 1.6mm Flat Washers 2.0mm x 278mm x 140mm Adhesive Backed Foam 2 Tape PROCEDURE: 1.
REAR LADDER 07-10 FJ CRUISER 8. Carefully install the Ladder onto the Lower Mounting Bracket using the Included (3) 8mm x 20mm Hex Bolts, (3) 8mm Lock Washers, (6) 8mm Flat Washers and (3) 8mm Hex Nuts, (Figure 7). Snug but do not tighten hardware at this time. 9. Attach the Upper Mounting Bracket to the Ladder using the included (2) 8mm x 20mm Hex Bolts, (2) 8mm Lock Washers, (4) 8mm Flat Washers and (2) 8mm Hex Nuts, (Figure 8). Snug but do not tighten hardware at this time. 10.
REAR LADDER 07-10 FJ CRUISER 6mm x 20mm Hex Bolt 6mm Flat Washer Metal Insert Tool Metal Insert Fig 3 Fig 4 Hold Tool firmly against surface while tightening Hex Bolt to expand Insert (2) 6mm x 20mm Hex Bolts (2) 6mm Lock Washers (2) 6mm Flat Washers Fig 5 Metal inserts will be flush with sheetmetal when properly installed (Fig 6) Pictured from below (Fig 7) Pictured with rear door open (3) 8mm x 20mm Hex Bolts (3) 8mm Lock Washers (6) 8mm Flat Washers (3) 8mm Hex Nuts Page 3 of 4 5/21/07 (AM)
REAR LADDER 07-10 FJ CRUISER (2) 8mm x 20mm Hex Bolts (2) 8mm Lock Washers (4) 8mm Flat Washers (2) 8mm Hex Nuts (Fig 8) Mark location for drilling Fig 9 Hold Tool firmly against surface while tightening Hex Bolt to expand Insert Metal Inserts (2) 8mm x 20mm Hex Bolts (2) 8mm Lock Washers (4) 8mm Flat Washers (2) 8mm Hex Nuts Fig 10 Installation Complete Fig 11 (2) 6mm x 20mm Hex Bolts (2) 6mm Lock Washers (2) 6mm Flat Washers Page 4 of 4 5/21/07 (AM)
