Page 1 of 10 DZ 946 / DZ 948 12/10/12
Dee Zee Wheel Well Toolbox Installation Instructions Congratulations on your purchase of a quality Dee Zee product. Dee Zee is recognized as having the highest quality running boards and accessories on the market today. We have earned this reputation by offering our customers a product they can be proud to place on their vehicles. Dee Zee meets all the criteria of manufacturing a custom-fit product which guarantees it to be the easiest product to install.
DZ 946 / DZ 948 Wheel Well Toolbox Wheel Well Toolbox A DZ 946/DZ 948 B X1 1/4” x 1” Black Sheet Metal Screw D PN 97B G B 2132L X1 v PN 70B H 1/4” Washer C ¼” X ¾” Black Hex Head Bolt E X4 PN 72B Left Mounting Bracket X8 Right Mounting Bracket B 2132R F X1 1/4” Hex Nut PN 71B X8 Foam Tape X16 X4 Tools Required Ratchet / Wrench 13mm / 10mm 3/8” 7/16” Drill Bit Sizes: 3/16” 1/4” Page 3 of 10 DZ 946 / DZ 948 12/10/12
1 Peel the backing from the adhesive on the foam tape (H) and apply 2 pieces to each bottom surface of the wheel well toolbox. Place the wheel well toolbox (A) into the truck bed so that the cutout of the toolbox goes over wheel well of the truck. Move toolbox (A) into desired location in bed of the truck making sure the hinges of the lid of the box are toward the inside of the truck bed. The left and right mounting brackets (B/C) are mounted as shown below.
2 Remove the wheel well toolbox (A) from the vehicle and examine the marked hole locations on the inside vertical lip of the bed. • If the back side of the lip is accessible at marked hole location to allow for installation of a nut (F) onto bolt (E) through lip then go to STEP 3 BELOW. • If the back side of the lip is inaccessible at marked hole location then go to STEP 4 BELOW.
3 If the back side of the vertical inside bed lip is accessible at marked hole location to allow for installation of a nut (F) onto a bolt (E) through bed lip then use ¼” drill bit at hole locations. Secure mounting brackets (B/C) to the inside of the vehicle bed rail using ¼” x ¾” hex head bolts (E), ¼” flat washers (G), and ¼” hex nuts (F). Do not tighten hardware.
4 If the back side of the vertical inside bed lip is inaccessible at marked hole location then use 3/16” drill bit for installation of sheet metal screws (D). Secure mounting brackets (B/C) to the inside of the vehicle bed rail using ¼” x 1” sheet metal screws (D). Do not tighten hardware.
5 Place the wheel well toolbox (A) back into the truck bed inside of the mounting brackets (B/C) as shown below. Use the existing holes in the mounting brackets (B/C) as a guide to drill two ¼” holes through the outside of each end of the wheel well toolbox (A).
6 Secure Wheel Well Toolbox (A) to mounting brackets (B/C) using ¼” x ¾” hex head bolts (E), ¼” flat washers (G), and ¼” hex nuts (F). Tighten all Hardware.
Page 10 of 10 DZ 946 / DZ 948 12/10/12