Installation Guide

Step 1: Location
Designate your installation location, choose an area
free of underground lines or pipes. We recommend 2-3
Stakes - one on each side of your tree/plant or three in
a triangular pattern. (Fig.1) Smaller flowers or potted
plants may only require one stake.
Step 2: Installation
NEW TREE INSTALLATION: If you are planting a brand
new tree, dig your designated planting area and place
your tree in the center of the hole. Insert stakes just
outside the tree’s root ball, and backfill the area with soil.
No pounding needed!
EXISTING TREE INSTALLATION: Drive the
stakes into the ground using a 3-5 lb. sledge
hammer. Make sure to place the caps on
the stakes when installing them in order
to prevent stake from breaking. Pound the
stakes into the soil until only the top hole
of the stake is above ground. (Fig. 2) Option
2: You can also drill into the ground with an
auger bit to clear pathway and more easily
place the stakes into the ground.
QUICK INSTALLATION STEPS
Deep Drip was specially engineered to water,
fertilize, and aerate your trees and plants, while
conserving up to 50% of your outdoor water use.
Our 4 convenient sizes accommodate everything
from flowers, potted plants, vegetable gardens,
shrubs, vines and new/small to established/large
trees and palms.
NECESSARY EQUIPMENT AND SUPPLIES
•
Protective Eyewear
•
Gloves (Optional)
•
Water Hose
•
Soil Softener (Optional)
•
3-5 lbs. Sledge Hammer or Auger Bit (Optional)
Fig. 1
Fig. 2
36”24”14”8”