Range Extender QUICK START GUIDE Model: WFI-19001
1 WHAT’S INCLUDED Range Extender Quick Start Guide
2 RANGE EXTENDER PARTS Antennas LEDs WPS Button Ethernet port Factory Reset: Check Power LED is green. Press and hold the WPS Button until the LEDs start to blink (about 12 seconds). Release the WPS button. The Range Extender will now be reset to factory defaults.
LED STATUS GUIDE 3 Power Off - no power Orange - device startup, Green - power on and ready Hub/Router Off - no connection Blinking green - WPS mode (attempting to pair) Solid green - connected with good signal Orange - OK signal Camera/Device Off - no connection Blinking green - WPS mode (attempting to pair) Solid green - connected with good signal Orange - OK signal LAN Illuminates when a device is connected by Ethernet cable
POSITIONING THE RANGE EXTENDER 4 The ideal location to place the Range Extender is half-way between the Deep Sentinel Hub and the Deep Sentinel Camera that has an unreliable or weak signal. The best connections are established when the Range Extender has a clear path between both the Hub and the target Camera.
The Range Extender relies on the Hub for a connection and it will be lost if: • The Hub is powered off or loses internet connection • The wireless signal of the Hub fails to reach the Range Extender • The Range Extender loses power Avoid placing the RangeExtender on the floor as this may weaken the signal. Power Outlets are typically at a fixed height, but avoid connecting the Range Extender to a powerstrip that is on the floor.
SETUP 5 The Deep Sentinel App provides step by step instructions to setup the Range Extender. To view useful tutorial videos, find troubleshooting tips, or get support, visit: deepsentinel.com/support Deep Sentinel Corp. 600 Main St. Ste C. Pleasanton, CA 94566 www.deepsentinel.com info@deepsentinel.
REGULATORY NOTICES This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
