Operation Guide

2) Click WiFi (wireless local area network) to turn on WiFi. If the device is successfully discovered,
you will see a signal named "DB Dolphin-XXX" in your WiFi list
3) After clicking "DB Dolphin-XXX", the page will jump to enter the WiFi password. The initial
password is: 12345678. After entering the password and clicking connect, the signal between the
phone and the sphere is successfully connected，take iPhone as an example
Software display interface function introduction:
In the main interface, click "Turn on Sonar" to enter the working mode. If there is no WiFi signal
connection, the status of WiFi disconnection will be displayed on the head, and you need to
reconnect in the settings. In the working mode, the water depth, water temperature and fish condition
information will be continuously obtained from the WiFi probe, and refreshed continuously from
right to left.Each display unit is described in detail below.
1) Water depth: The depth detection range is 0.5-100m, and the display accuracy is 0.1m.
2) Water temperature: the water surface temperature is detected, and the probe has a temperature
sensor in contact with the water surface.