User's Manual

Operation 49
Operation
4
7 Set the intensity of UV processing. You can
select the UV processing intensity level
from [Normal] , [High].
[NORMAL]
It takes about 15 minutes for UV
processing of a 25 square meter space.
[HIGH]
UV processing ability is higher than NORMAL
mode. It takes about 30 minutes for UV
processing of a 25 square meter space.
,
Note
y Press [ ] (Previous) to move back to the
previous screen.
8 Before starting UV processing, install the
door sensor on the door handle and press
[OK].If the door sensor is turned off or not
paired, the guidance screen is displayed as
shown below.
9 Press [Start].
The UV processing-ready screen will
appear.
The robot waits for the set amount of
time to allow the user and all other
persons to exit the target space before
starting UV processing.