Instructions

3
SERIES
ITALIANOPOLSKIESPAÑOL
FRANCAISFRANCAIS FRANCAISFRANCAIS
FRANCAISDEUTSCHENGLISH
OPERATION
Each cable crossover has connectors and corresponding sockets that enable you to connect cable crossovers in
the same series endlessly with one another. We also call this a line. Generally, lines are stable enough to be walked
on or driven over without any additional precautions. If the is subject to higher demands occasionally, so that there
is a risk of the line shifting during use, we recommend additionally anchoring the line to the ground or floor. The
Defender III incorporates special holes for anchoring in the dog bone connectors. With all other crossovers, a hole,
through which you can then insert an anchor, should be drilled directly inside a cable channel. After installation
(except for the Compact and Office models), the lids can be opened by pulling them upward. They snap into the end
position automatically and stay open until you close them again, thus making it easier to run your cables. After run-
ning your cables, close the lid. When doing so, make certain that the lid closure snaps into the base securely. This is
the only way to ensure that the lid stays closed under load.
PURPOSE
All cable crossovers in the DEFENDER series are designed to protect cables of all types against damage. In order to
fulfil maximum operational requirements, all of our cable crossovers comply with the standards of the Low Voltage
Directive.
RESPONSIBILITY
Each user is responsible for the manner of installation and selection of cables to be protected with the help of the
DEFENDER cable crossovers. We warrant the load bearing capacity of our crossovers only when they are used
properly.