Defender 4K Product Manual
Table Of Contents
- 1 THANK YOU
- 2 WARRANTY INFORMATION
- 3 DISCLAIMERS
- 4 SAFETY WARNINGS
- 5 COMPLIANCE STATEMENTS
- 6 WHATS INCLUDED
- 7 GETTING STARTED
- 8 START UP
- 9 USING YOUR SYSTEM
- 10 PLAYBACK
- 11 EXPORT
- 12 VIDEO RECORD SETTINGS
- 13 CAMERA SETTINGS
- 14 CONFIGURATION
- 15 MANUAL CAMERA SETTINGS
- 16 HDD SETTINGS
- 17 SYSTEM MAINTENANCE
- 18 ANALYTICS (IP CAMERA REQUIRED)
- 19 CAMERA INSTALLATION
- 20 HARD DRIVE INSTALLATION
25
START AUTO-SWITCH
When set the view will switch between cameras (channels). This option will only work when the Dwell
Time is setup in the Defender 4K Menu. See section 14.3.1 General
for setting Dwell Times.
This will show the camera view for the selected amount of time before switching to the next camera,
like a slide-show.
START RECORDING
Select between Continuous and Motion Detection recording. This is the same feature that was set during
the Setup Wizard. When selected the system will record all day on all cameras based on your selection.
ADD IP CAMERA
IP Cameras are not available from Defender for the 4K system. To add an IP camera, follow the
direction provided with your camera.
PTZ CONTROL
PTZ Cameras are not available from Defender for the 4K system. Use the PTZ controls on-screen to
set up your camera.
OUTPUT MODE
Output Mode changes the appearance of the image on the screen. Click to select
between the options listed.
This changes the view for all cameras when
selected.
CONTENTS